How to Make Shoes Clips

We have collected again the diy shoes clips. It is easy to make and it only takes about 20 minutes to make!. Follow step by step guides to make the shoes clips. It is pretty and simple. So we hope you will like this.

ကိိုယ္ရဲ႕ရႈးဖိနပ္ကို အလွျပန္ေဖာ္နည္း

ရႈးဖိနပ္ကို ဒီလိုေလးနဲ႔ အလွျပန္ေဖာ္ရင္ fancy မက်ဘူးလာ..ပါတီပြဲတို႔ ၊ wedding မွာ ၀တ္ခ်င္ရင္ ပိုျပီးအဆင္ေျပတယ္ေပါ့... အားလုံးအတြက္ လြယ္ကူမယ့္ဟာေလးမို႔ မွ်ေ၀ေပးလိုက္ပါတယ္.... ပုံထဲကအတိုင္း မဟုတ္ရင္လည္း ကိုယ္ၾကိဳက္တဲ့ ပိတ္စေရာင္ကို ေရြးျပီး အျခားဒီဇိုင္းနဲ႔လည္း ျပဳလုပ္ႏိုင္ပါတယ္....

What you’ll need:

- 1/2 yard of white or ivory lace (can do variations with any style/color fabric, or purchase vintage lace tablecloth)
- Thread and needle
- Hot glue gun
- Scissors
- A little bit of white or ivory felt.
- Vintage earrings or brooches
- Needle-nosed pliers
- Any pair of shoes that need a little dressing up!

Instructions:

Step 1: Cut the lace into pieces that measure approximately 3 inches long by 2 inches wide. You can play around with these sizes to make fabric flowers bigger or smaller, as desired. You will need about 6 of these per flower, 12 total.

Step 2: Fold the pieces in half and tie some thread around the middle and secure with knot.

Step 3: Take one of fabric pieces and place on top of another one, middles together, and perpendicular to each other, forming an X. Take needle and thread and put a could stitches through where the middles meet. Once you’ve got it secure, add another fabric piece in the same manner, filling in the holes, and add a few more stitches. Do this until all fabric pieces are used. Fluff the newly formed flower. Repeat for second flower.

Step 4: Take the scissors and trim the edges of the flowers, creating a rounded shape. Trim off any stray pieces.

Step 5: Cut out two pieces of felt about the size of a quarter, and glue to the bottom of your flowers, for extra hold.

Step 6: Use the needle nosed pliers to remove the back fasteners of the earrings. The ones I used were clip on’s so I had to remove the clip part. If they are regular earrings, you may have to clip off the point. Be careful not to damage the jewelry too much.

Step 7: Put a nickel sized dollop of hot glue on the back of the earring, and place firmly in the middle of the fabric flower. Hold for a few seconds, and then set down face up to make sure it dries in the right place. Repeat for each flower.

Step 8: Glue each flower to the top of each shoe. Press firm, let dry. Once the glue is dry, you can put a couple discreet stitches through the flower into the shoe, for extra hold. Be sure to start from underneath, so the thread knot doesn’t show.